Vinyl alcantara

Are you looking for a vinyl to make your car like the lamborghini urus? Welcome and welcome newness in vinyl, new vinyl alcantara. In Audioledcar we are very sure that this vinyl will draw attention where it passes.

It offers a new technology of application and is that just apply a little bit of heat, you can put the vinyl on any surface regardless of its length, curvature, roughness, etc, This vinyl can be used both indoor and outdoor.

We work with the best of the best in the industry, WrapWorkers leading brand in the sector of wrapping for your ease of install and for its duration.

I would like to put the vinyl alcantara in my car, how can I do it?

This vinyl does not cease to be thermo-adhesive, which means that to take advantage of its functionality we need to apply heat (the heat can be a hair dryer at a medium temperature), to activate the adhesive. Being a vinyl with a velvety texture, we recommend that for your setup is to use our spatula. Why? Because our spatula has a side-lined with a material similar to the cotton that does not damage the vinyl to stretch it or remove possible air bubbles. Always in the same direction as that found the velvet of the vinyl.

How long does it last vinyl?

The vinyls that we work with brand WrapWrokers, can last on the exterior of a vehicle between 3-4 years. And the interior even more. The durability of vinyl always depends on the care that is right-that we explain in the next question.

I put the vinyl alcántara, but I don't know how to wash a car without estropeé

Do not worry if you have this doubt, we always advise that when we put out vinyls that they have a nice `special out of or in car washes, or use the guns, water pressure, etc, will Not stop being a product that is installed, and that any misuse of the tools or the direction in which to apply water, soap, etc., you may reach out to damage the vinyl leaving damage very large.

We strongly recommend using products of shampoo as the ALCANTARA CLEANER BADBOYS, to use the cleaner, you need to shake the product and above all, the most important thing to aspire to the surface that we are going to clean up. We proceed to take the cleanner in the packaging foam, and proceed to take the product on the brush and to clean up. Later when we finished, we cleaned the surface with a microfiber.

The vinyl when you install it, you can form bubbles and wrinkles?

We work with the best suppliers in the sector of the vinyl, WrapWorkers that thanks to your technology setup can be molded with ease on the model.

Don't worry if you get any bubbles at the time of install, with the help of heat, can raise the vinyl and mold it again to fit with a spatula to the surface.

Recommended that once you have installed the vinyl, make sure that you do not have or shock, or friction, or is found with high and low temperatures (water, snow)

In case of any doubt that may arise, please do not hesitate to get in touch with our agents either via email, chat or phone.

Also if you are looking for professionals in charge of the sector wrapping, ask without commitment.