Vinyl Gray cement solid (whole car) 1500 x 150 cm

Vinyl Gray cement solid (whole car) 1500 x 150 cm Audioledcar.com

Vinyl Gray cement solid (whole car) 1500 x 150 cm adhesive technology with AirDrain and moldable with heat. The micro-drilling avoids any kind of pomp by the application of heat. In addition to its structure allows you to mold it with heat to make the forms more curves as if it was a piece of gum you were.

Frequently asked questions of the Vinyl Gray cement solid (whole car) 1500 x 150 cm:

I'd like to place a horizontal stripe through the vehicle, apart from the vinyl do I need something more?

If you want to have the best results we recommend our tools to be able to install the vinyl to perfection as our spatula that has a new system of straightening in fabric so that you avoid any type of damage. Also our cutter, perfect for clean cuts and long, that has a protection to avoid any court at the time of install. The latest addition in the tools of vinyl is the ribbon cutting professional for vinyl, perfect for those professionals in the sector. We recommend that when you go to install vinyl to use gloves, we avoid any kind of blemish on the product when we're dropping.

-

I've never placed vinyl and wanted to put it in some interior parts of the car, what should I take into account the time of install?
If you have never before has done work with vinyl, that do not panic. In Audioledcar we recommend the best tips and techniques to ensure a good result. The first thing to keep in mind is to have the clean surface. Later we will go by placing the vinyl lifting it off very slowly. With the help of a heat gun or a hair dryer at a medium temperature will provide you with small movements of the vinyl (the latter do so because our vinyls are thermo adheribles and the glue is activated thanks to the heat). With the help of a spatula, we will be smoothing the vinyl placed to ensure that it is completely smooth and stuck to the surface.
*In Audioledcar we recommend that before you perform any installation of vinyl, will test the product before at a surface in order to see the behavior of the material, its mode of installation, and in some way, take practice*.

-

When you put the vinyl I've noticed that it appears an air bubble and I don't know how to fix it.
If this is the first time you install vinyl is very possible that this will happen but we'll give you an advice to be able to correct this. Normally what we do is very carefully lift the vinyl to the area where the bubble of air with the aid of a heat gun or in his absence a hair dryer to apply it in vinyl to an average distance to activate your grip and with the help of a spatula will smooth out the area, leaving it perfect and without any flaws. In the event that we have a bubble, wrinkle, etc. we can again proceed with the same procedure.