LED T4
LED bulbs T4 Car and Motorcycle
If you want to change the lighting of your dashboard, the led bulbs T4 of ZesfOr® are your best option.
The quality of their led and its power of illumination, will give a new look to your instrument panel.
With the time the halogen bulbs traditional are losing power or even burned, but with the light bulbs T4 ZesfOr® you'll forget all these problems.
This cap comes in two models, the T4.2 and the T4.7
The difference is the mm of your base:
-T4.2 10 mm
-T4.7 11.5 mm
Both models can be found in our web site and both models you can find them in different colors.
Light bulbs T4 ZesfOr® are available in blue, red, green, and of course white.
This cap is usual to find it in the boxes of instruments, in the interior, on spokes account kilometers or even lighters.
Advantages give us the LED bulbs
LEDS have several considerable advantages in comparison to light bulbs halogenas.
Are the following:
– Longer service life
– Lower heat generation
– More light output
Due to the long duration of this type of light bulb, you won't need to install any other in the entire lifespan of your vehicle.
You might even be removed and re-use in your next car, because it can be recycled without problems.
The LEDS use much less energy than incandescent lamps.
Give a lot more light with less power and generate at the same time less heat. This is an advantage when the space behind the dashboard is limited.
The LEDS shine much more than the bulbs of halogen-traditional, no heat build up.
In addition, the LED lights can be dimmed to the extent that you want.
Change the lights of a speedometer for LED bulbs is in principle very simple. All you need to do is the following:
– Instructions for dismantling the dashboard
– Right tools
– Peace of mind and good mood
Normally, the bulbs are mounted on the rear panel of paintings by swivel connectors. To reach them, remove the instrument panel.
Depending on the type of vehicle, this may be a matter quite complicated. In any case you should try to disassemble the instrument panel without touching the steering wheel, as there is the airbag.
Once dismantled the speedometer, remove the halogen bulbs traditional with pliers sharp. The bases outstanding are taken and rotated 90°. Then you can draw.
Now you'll be able to measure the base of your light bulbs to determine which type of cap is.
Our bulbs T4 ZesfOr® are ready to be installed, you only need to insert to the reverse.
You can easily change the color of your dashboard, as we have many different colors.
You can find the T4 ZesfOr® for your instrument panel in pure white, blue, red, and green.
Not only can you use them to change old light bulbs, you can also use to change the look and feel of your dashboards, configuring it to your liking lighting.
Can you put light bulbs T4 ZesfOr® in any bike or car?
Yes, but you should make sure before that this is the model you need, because the light bulbs t4 can be t4.2 10mm and t4,7, 1.5 mm.
It is normal that in the manual of your vehicle will specify if they are T4 and the measures, if you don't put it, you can always take out the bulb and measuring its base.
If you have any questions you can send us a photo and we will confirm for you that the bulb is the one that you need
Before you install any bulb make sure the switch is off.
If when you put the new led bulb T4 ZesfOr®, this does not turn on, try to turn around because the leds have polarity.
Specialists in led lights T4, any doubt contact us
9
Products in this category.