Restore headlights

In this category you will find the solution to this great problem, the headlights have deteriorated and have been opaque. Thanks to this great selection of products that will not be a problem.

How do you know what kind of product you should use to restore headlights?

Depending on the deterioration of our beacon, we will need to use a specific type of product, inside of the deterioration, we will distinguish three degrees:

Grade 1: our lighthouse is beginning to lose transparency.

Grade 2: the lighthouse is completely yellow but has not lost its consistency.

Grade 3: the lighthouse in addition to being yellowish has lost consistency.

For the grade 1 we will use the wipes restoration of headlights works in two simple steps, we get the look of original of our vehicle.

For degree two, we will use the kit lacquer special headlights and pilots car +sandpaper (headlights, we just need to sand the surface, removing the top layer of lacquer until this is fully opaque, we will remove the dirt and apply the lacquer. We will get a result almost magical and instantaneous.

For the grade 3 we have two options, the previously annotated the kit lacquer special headlights and pilots car +sandpaper (headlights, or the restoration kit headlight of Chemical Guys.

This last kit is recommended for headlights in a very bad state, and requires drill or polisher:

The first thing you have to do is to clean your headlights with soap and water.

And we'll start using the adhesive tape around the lighthouse to protect the area from possible scratches.

Then we put the disk platter in the instrument of the drill and sanding Discs grit P500. We started sanding the lighthouse to remove all the defects it may have.

Then use the sanding Discs grit P800 to remove all the scratches that have been created with the previous record used.

And the same with the next step sanding Discs grit P2000 that we will reduce the scratches created by the disk P800.

*Important * for the next step you'll need to use the grain Discs P3000 to remove the scratches created by the P2000 but should be cooled with water. This is important to keep in mind since if water is used, the result will not be the same.

The next step will be to put the beret polished in the dish and add a small amount of the substance of rubbing compound.

Start to Polish until the surface is brilliant.

*Important* the step should be cooled with water.

As a last step, you must clean the headlight with soap and water to finish off any rest.

And voila, you already have your headlamp fully restored.

My lighthouse has suffered a stroke and has an roce of another vehicle, What product should I use?

In this case, the first is to assess the damage, if it is a touch surface, you can use the wipes restoration of headlights it works, if it is deeper, first try with the kit lacquer special headlights and pilots car +sandpaper (headlights, if we are unable to remove it completely, we must use the latest product the restoration kit headlight of Chemical Guys.

I am unsure of the status of the lighthouse, What should I do?

In that case you only have to send an email to our customer service department with a photo of the same and we will be happy to help you.